Enable DHCP On Your Epson TM-T20 Printer

 

To get your Epson Slip Printer paired with the humble iPad Till using your Wi-Fi Router, you will need to first enable DHCP on your printer. To do this you will need to connect the printer to a PC. Follow the guide below to complete this:

1. Ensure your PC is connected to the Wi-Fi Signal from your in-store Wi-Fi Router. 

2. Click here to download the EpsonNet Config drivers.



3. Once the drivers have downloaded successfully, click Run and accept all the prompts to install the EpsonNet Config drivers to your PC.

4. Turn your Epson Printer on and connect it to your Wi-Fi Router using an ethernet cable.

5. Navigate to and click on the Start Button in the bottom left hand corner of your PC.
   
    Find and click on EpsonNet file

    Followed by clicking on the EpsonNet Config V4 File

    And finally, click on EpsonNet Config

6. Please be sure to wait a few minutes whilst EpsonNet picks up your printer.

If it does not appear, ensure your printer is on and the ethernet cable is plugged in correctly and click "Refresh"

7. Once EpsonNet picks up your printer, click on the device (highlighting the device) and then navigate to and click on Configuration.

 

8. On the left of your screen, navigate to TCP/IP and click on "Basic".

Click on "Automatic" and make sure that there is a tick next to - "Set using Automatic Private IP Addressing (APIPA)"
Follow that by clicking on "Transmit" on the bottom of the page.

9. You will be prompted by a pop up screen to ensure that the printer is in an idle state. Navigate to and click on "OK"

10. The new settings will be transmitted to your printer. Once it shows 100% click on "OK"

11. Once complete, click on Refresh and your printer will now show as having an IP Address.      

Please take note of the new IP Address from your Printer.

This will allow the humble iPad Till to pick up your printer.